AVR70 engelsk manual 11/01/98 11:57 Side 13
Remote Control Programming & OperationENGLISH
13
Another group of keys may only be
programmed with one remote code. The
code contained in these keys remains the
same regardless of the source selection.
Clearing the Remote Memory
In normal operation, codes for a new
WARNING: These keys transmit codes
that are vital to the operation of thedevice may be programmed Oover�
1. Slide Use/Learna switch at the topthe codes that have been previously
product. It is not recommended that theyleft corner of the remote to the right soprogrammed into the remote. It is also
be programmed with alternative codes, as
that it is next to Learn.possible to clear the memory for
it may then be impossible to operateindividual keys, or for the entire remote.
certain functions of the receiver.
2. If one of the multi-function buttons When
Auxis being programmed press the sourcea memory position is cleared, the remote
button (i.e. CD, VCR, etc.) you wish towill return to the original factory preset
Cursor Up �
have this function associated with. If youcommand.
Pro Logicare programming a single function key,
Delayproceed to the next step.To clear the memory for a specific
Cursor Down Uindividual key location, put the
Dolby 3 Stereo3. Press the button on the remote that Use/Learnswitch in the Learn
Memois to be programmed. Note that theposition. Press the Main Power Offb
Learning yLED will illuminate.button and the button to be cleared at the
Cursor Right �same time. Both the Sending and
Movie
4. Place the remote head to head with theLearningindicators will light
Screen Displayremote control whose function is beingmomentarily. When
Cursor Left �learned. The two remotes should be nothe lights go out, the memory has been
Matrixmore than 8 inches apart.cleared of the user programmed code and
returned to the factory preset. Return the
Panel Display
Select5. Press and hold the button on theUse/Learn aswitch to the Use
transmitting remote corresponding to theposition when you are finished.
Hall
function to be memorized until the
SpeakerLearningLED starts to blink. When theTo clear the remoteOs entire memory
Main Volume Up �LED goes out, release the button on theand return all keys to their factory preset
Stereotransmitting remote. The function codecommands first put the Use/Learna
Test Noisehas been successfully captured.switch in the Learn position. Then press
the Main Power On button b and
Main Volume Down U
NOTE: If both LEDs flash during aconfirm that the Learning indicator y
Adjustprogramming operation, it indicates thathas illuminated. While continuing to
Mute
the remoteOs memory is full or that press the Power On button, press and
RDS PTYthe remote codes from the transmittinghold the Power Offb button until the
RDS AFremote are not compatible with the unitOsLearnindicator goes off for about 3
signal format.seconds. It will then blink twice. Then
To program the remote, you need therelease the two buttons. This indicates
remote of the device, whose functions6. Continue to program any additionalthat the memory has been cleared of any
shall be programmed. Note that it is notremote commands required using stepsuser programmed commands and that
necessary to program all keys, only those2 through 5. When you have finishedthe original commands have been
that are required to operate the subjectprogramming the remote, slide therestored. Slide the Use/Learn switch
device. Keys not programmed will retainUse/Learnswitchtotheleftsothatitback to the Usea position to return
the codes preprogrammed at the factory.is in theUse position.the remote to normal operation. |
ACEC
